OC Library EinScan-SE 3D Scanner
A guide to the use and best practices of the OCL's 3D scanner.
Fixed Scan
The scanner can take a single-frame shot of your object from one angle. This is useful if your object is too large for the turntable or you only need one specific angle- especially if there are gaps in your original scan.
You can set the scanner to Fixed Scan mode by putting the "With Turntable" switch in the Off position.
The scan will not pick up any other angle of your object.
See the Scan Refinement page for information on how to complete your scan. See the Other Tips and Tricks page for information on how to pick up additional scans with the turntable when your object is awkwardly shaped or you need the camera to focus on one difficult angle.
- 3D Scanning Series Video Two: Scanning an ObjectThis video will show you the basics of 3D scanning on the NSU Florida Library’s Einscan SE 3D scanner. This includes scanning using the automatic turntable, scanning using a fixed scan, and editing scans. Please refer to the first video of this series for information on how to set up a new project.